Free DES-DD23 Sample Questions — Specialist - Implementation Engineer, PowerProtect DD

Free DES-DD23 sample questions for the Specialist - Implementation Engineer, PowerProtect DD exam. No account required: study at your own pace.

Want an interactive quiz? Take the full DES-DD23 practice test

Looking for more? Click here to get the full PDF with 36+ practice questions for $4 for offline study and deeper preparation.

Question 1

Which command is used to check if NFS is enabled?

  • A. nfs enable
  • B. nfs status
  • C. nfs show clients
  • D. system show
Show Answer
Correct Answer:
B. nfs status
Question 2

Which port/protocol is used when using a syslog server to monitor a PowerProtect DD system?

  • A. 514/UDP
  • B. 2051/TCP
  • C. 514/TCP
  • D. 2051/UDP
Show Answer
Correct Answer:
A. 514/UDP
Question 3

An administrator monitors the performance statistics of a PowerProtect DD appliance. Low disk-write rates are shown, and the network inbound traffic is high. What is the most likely cause of this behavior?

  • A. NVRAM failure
  • B. Disk failure
  • C. Expired segments
  • D. Known segments
Show Answer
Correct Answer:
A. NVRAM failure
Question 4

Which component of PowerProtect DD is Data Invulnerability Architecture a feature of?

  • A. VTL
  • B. DDOS
  • C. DD Boost
  • D. CIFS
Show Answer
Correct Answer:
B. DDOS
Question 5

Which command is used to start the initial CLI configuration wizard?

  • A. config setup
  • B. install config
  • C. config
  • D. setup
Show Answer
Correct Answer:
A. config setup

Aced these? Get the Full Exam

Download the complete DES-DD23 study bundle with 36+ questions in a single printable PDF.

Purchase Full Exam PDF | $4