Which of the following protocols can be used to prevent loops on a Layer 2 network with redundant links?
- A. VRRP
- B. STP
- C. ARP
- D. UDP
Free H12-811 sample questions for the HCIA-Datacom V1.0 exam. No account required: study at your own pace.
Want an interactive quiz? Take the full H12-811 practice testLooking for more? Click here to get the full PDF with 157+ practice questions for $10 for offline study and deeper preparation.
Which of the following protocols can be used to prevent loops on a Layer 2 network with redundant links?
The TCP protocol uses the three-way handshake mechanism to establish and disable connections. Therefore, TCP supports reliable data transmission.
UDP is connectionless. As such, which of the following must be used to ensure transmission reliability?
Which of the following commands is used to display the OSPF neighbor relationship establishment?
What of the following statements is correct regarding Access Control List types and ranges?
Which of the following OSPF states can be used to indicate that an adjacency relationship has been established?
The administrator wishes to change name of the router. Under which view should the administrator be in order to achieve this?
Which of the following commands is used to configure the country code on an AC?
The data link layer uses PPP encapsulation. The IP addresses of the two ends of the link can be in different network segments.
The router that runs OSPF first enters the Full state and then synchronizes the LSDB.
Which of the following commands sets the data forwarding mode on an AC to direct forwarding?
After an Eth-Trunk in LACP mode is created, devices on both ends send LACPDUs to elect the Actor. Which of the following parameters in LACPDUs determine the Actor election? (Choose all that apply.)
Which of the following statements is true about the edge port in RSTP?
What is the protocol number of OSPF at the network layer?
Which of the following command line views exist on the Versatile Routing Platform (VRP)? (Choose all that apply.)
Which of the following MAC addresses cannot be used as the MAC addresses of host network adapters?
After the administrator performs the configuration shown in the figure on a router, which of the following commands can be used to specify a short lease for addresses assigned using DHCP? ip pool pool1 network 10.10.10. 0 mask 255. 255. 255. 0 gateway-list 10.10.10.1
Which of the following statements about IPv6 anycast addresses are true? (Choose three.)
Which of the following routes has the highest priority?
In a broadcast address, all host bits are set to 1 and a broadcast address can be used as a host address.
Download the complete H12-811 study bundle with 157+ questions in a single printable PDF.