Free JN0-363 Sample Questions — Service Provider Routing and Switching, Specialist (JNCIS-SP)

You want to see a detailed list of all established BGP sessions. In this scenario, what would be a valid command to accomplish this task?

• A. show bgp neighbor
• B. show route receive-protocol bgp <neighbor IP address>
• C. show route protocol bgp
• D. show bgp summary

Which two interface types are used as tunnel endpoints? (Choose two.)

• A. ge
• B. ae
• C. gr
• D. ip

Which OSPF database packet determines which router is in charge of the database synchronization and the transferring of LSA headers between the two systems?

• A. link-state request
• B. database description
• C. hello
• D. link-state update

By default, which two statements are correct about switch ports on a Junos device? (Choose two.)

• A. Trunk ports receive and transmit untagged traffic
• B. Access ports receive and transmit tagged traffic
• C. Trunk ports receive and transmit tagged traffic
• D. Access ports receive and transmit untagged traffic

You are bringing a new network online with three IS-IS routers using default Junos election priorities. The routers are configured as Level 2 only IS-IS routers. Which statement is true about the DIS election in this scenario?

• A. The router with the highest numerical lo0 IP address will be elected as the DIS
• B. The router with the lowest MAC address will be elected as the DIS
• C. The router with the lowest numerical lo0 IP address will be elected as the DIS
• D. The router with the highest MAC address will be elected as the DIS

What is a key differentiator of generate routes from aggregate routes?

• A. Generate routes cannot be used as a gateway of last resort
• B. Generate routes use a forwarding next hop
• C. Generate routes have a default next-hop value of reject
• D. Generate routes have a default preference value of 210

Which two statements are correct when using LDP? (Choose two.)

• A. The inet.3 table will contain a full mesh of label-switched paths to other LDP-enabled routers
• B. LDP label-switched paths are created by configuring LDP on at least one physical router interface
• C. LDP label-switched paths are created by configuring LDP on the loopback interface
• D. The inet.3 table will contain only the paths explicitly defined

You are implementing traffic engineering in your MPLS network. You must ensure that the MPLS routes are used to traverse your network. Your solution should not affect IGP routes in your route tables. In this scenario, which traffic engineering setting will accomplish this behavior?

• A. bgp-igp-both-ribs
• B. mpls-forwarding
• C. bgp-igp
• D. bgp

Which statement is true about the BGP active state?

• A. The BGP active state is the initial state where all BGP traffic is refused
• B. The BGP active state is when BGP attempts to acquire a peer by initiating a TCP connection
• C. The BGP active state is when BGP waits for the TCP connection to be established
• D. The BGP active state is when BGP exchanges update, notification, and keepalive messages with its peer

You are asked to create connections between routing instances on the same Junos device and route between the connected instances. What are two ways to accomplish this task? (Choose two.)

• A. Use loopback interfaces
• B. Use an IRB interface
• C. Use logical tunnel Interfaces
• D. Use physical interfaces